Peptide / Unit conversion

BPC-157 reconstitution calculator

Enter your BPC-157 vial size, the volume of liquid added and the dose to calculate concentration and syringe units.

Your inputs determine the result. This calculator does not recommend dosages.

Live readout

Set your draw.

Enter your vial strength, diluent, and dose to see the draw.

Mode
Resulting concentration -- mg/mL
Doses per vial --
Syringe

Conversion follows standard mg, mL, and U-100 syringe references.

Performs unit conversions only. Not medical advice. Consult your healthcare provider.

Save preset

After saving, open Presets at the top of the calculator to recall this setup.

Saved presets

No saved presets

Save a conversion from the calculator to recall it later.

    Units chart

    BPC-157 units chart (mg to U-100 units)

    BPC-157 units chart: mg to U-100 units

    BPC-157's PinPoint entry uses a 5 mg example vial. Its amount chart uses the vial total directly, including a 0.1 mg first row.

    Vial concentration

    Water mL is treated as final solution mL in these columns.

    BPC-157: concentration in mg per mL
    Vial contents1 mL water2 mL water3 mL water
    5 mg5 mg/mL20 U-100 units per mg2.5 mg/mL40 U-100 units per mg1.6667 mg/mL60 U-100 units per mg

    Example vial size (input): 5 mg. No source is cited for this size; it is an arithmetic input, not a sourced fact.

    Amount to units

    Example amounts (arithmetic only, not doses).

    BPC-157: amount to U-100 syringe units
    Amount (mg)5 mg + 1 mL5 mg + 2 mL5 mg + 3 mL
    0.1 mg2 units4 units6 units
    0.25 mg5 units10 units15 units
    0.5 mg10 units20 units30 units
    1 mg20 units40 units60 units
    2.5 mg50 units100 units150 unitsover one syringe

    Cited amounts

    No human dose has been established. The amount table contains arithmetic examples only.

    How to read this chart

    units = amount ÷ (vial mg ÷ water mL) × 100

    The reconstitution calculator walks through each step, and units to mg converts between mg, mcg, mL and units.

    Working from the 5 mg example vial (input)

    The 5 mg per vial figure is an example vial size (input). Dividing by 50, 20, 10, 5, and 2 gives the five example amounts: 0.1, 0.25, 0.5, 1, and 2.5 mg. At a final solution volume of 2 mL, the middle 0.5 mg row occupies 0.2 mL, or 20 U-100 units. This row represents a tenth of the vial. Its volume becomes 0.1 mL in the 1 mL column and 0.3 mL in the 3 mL column, preserving the same fraction.

    Units, mL and mg/mL

    BPC-157 dosage in units and mL

    Searches for BPC-157 dosage in units or in mL are conversion questions. Units and mL both measure volume, and what a volume holds depends on how the vial was mixed. The first table gives the concentration of a 5 mg BPC-157 example vial (input) at 1, 2 and 3 mL of water; the second shows how many U-100 units each share of the vial takes, and what that share holds. Neither table sets a dose.

    BPC-157 5 mg vial: concentration, units per mg and what 10 units hold, by water volume
    Water added Concentration Units per 1 mg 10 units (0.1 mL) holds
    1 mL 5 mg/mL5,000 mcg/mL 20 units0.2 mL 0.5 mg500 mcg
    2 mL 2.5 mg/mL2,500 mcg/mL 40 units0.4 mL 0.25 mg250 mcg
    3 mL 1.67 mg/mL1,666.67 mcg/mL 60 units0.6 mL 0.1667 mg166.7 mcg
    BPC-157 5 mg vial: U-100 units per fraction of the vial, by water volume
    Fraction of the vial Holds Units in 1 mLUnits in 2 mLUnits in 3 mL
    1/20 one twentieth 0.25 mg250 mcg 5 units 0.05 mL 10 units 0.1 mL 15 units 0.15 mL
    1/10 one tenth 0.5 mg500 mcg 10 units 0.1 mL 20 units 0.2 mL 30 units 0.3 mL
    1/5 one fifth 1 mg1,000 mcg 20 units 0.2 mL 40 units 0.4 mL 60 units 0.6 mL
    1/4 one quarter 1.25 mg1,250 mcg 25 units 0.25 mL 50 units 0.5 mL 75 units 0.75 mL
    1/2 one half 2.5 mg2,500 mcg 50 units 0.5 mL 100 units 1 mL 150 units 1.5 mL over one 100-unit syringe

    BPC-157 5 mg reconstitution: worked example

    A 5 mg BPC-157 vial mixed with 2 mL of bacteriostatic water holds 2.5 mg/mL, or 2,500 mcg/mL. On a U-100 syringe 10 units is 0.1 mL, and at this concentration it holds 0.25 mg (250 mcg), one twentieth of the vial. The whole 5 mg is 200 units at 2 mL, more than one 100-unit syringe holds. Mixed with 1 mL instead, the vial is 5 mg/mL and 10 units hold 0.5 mg; with 3 mL it is 1.67 mg/mL and 10 units hold 0.1667 mg.

    A vial that holds BPC-157 and TB-500 together is a blend, and the BPC-157 TB-500 blend calculator converts both components from one draw.

    Arithmetic from the example vial size (input) shown, not doses. Water mL is treated as the final volume; a different vial entered in the calculator above gets the same formulas.

    Compound profile

    BPC-157 at a glance

    BPC-157 is a synthetic 15-amino-acid peptide studied in preclinical research on tissue injury.[1] The library marks human model data as limited and does not characterize a human response from that source.[1]

    Regulatory status
    FDA listed BPC-157 among bulk drug substances for compounding that may present significant safety risks, a nomination later withdrawn; FDA says it lacks sufficient information to know whether the drug would cause harm when given to humans.[2]
    Half-life
    About 15 minutes after intravenous dosing in rats (5.3 minutes in dogs) in the cited study; no human value.[1]
    Route
    The cited study gave BPC-157 intravenously and intramuscularly to rats and dogs. It has no data for subcutaneous, oral or sublingual use.[1]
    Category
    Peptide
    Vial size
    5 mg, example vial size (input)

    Evidence

    What the research says

    The cited pharmacokinetic study investigated BPC-157 in rats and beagle dogs after intravenous and intramuscular administration. Researchers measured absorption, tissue distribution, metabolism, and excretion, using both intact-peptide assays and radiolabeled material. This was an animal disposition study, rather than a human study of injury recovery.[1]

    Intact BPC-157 had an elimination half-life below 30 minutes in the studied animals. Intramuscular bioavailability differed by species: approximately 14% to 19% in rats and 45% to 51% in dogs. The library's quarter-hour reference derives from the rat intravenous context and retains that species qualification.[1]

    Radioactivity measurements followed peptide fragments through urine and bile, while metabolism produced smaller peptides and amino acids. Tracking a radioactive label can therefore capture material after the original peptide has broken down. These experiments do not provide a measured human subcutaneous half-life or establish a combined BPC-157 and TB-500 regimen.[1]

    Published human reports are few and uncontrolled: a 2025 intravenous safety pilot in two adults (PubMed 40131143) and a 2021 retrospective chart review of 16 patients given knee injections (PubMed 34324435). No human dose has been established.[3][4]

    Timing

    Half-life and timing

    About 15 minutes after intravenous dosing in rats (5.3 minutes in dogs) in the cited study; no human value.[1]

    Calculator details

    About this calculation.

    What does a BPC-157 dosing chart establish?

    A chart can show conversions from an entered amount, but the animal study does not establish a human dosing schedule. Its 5 mg vial is an example vial size (input), not a sourced fact. Any numeric conversion remains separate from the limited human evidence described in the guide.[1]

    Does a BPC-157 calculator convert milligrams to micrograms?

    One milligram equals 1,000 micrograms in the arithmetic used here. Thus the 5 mg example vial represents 5,000 micrograms in total. Converting units preserves the quantity and does not turn the example total into a human research amount.

    Does the BPC-157 guide establish a BPC-157 and TB-500 blend schedule?

    The cited study gave BPC-157 alone to rats and dogs. It did not test BPC-157 with TB-500, so no combined schedule follows from it.[1]

    What concentration is BPC-157 at 5 mg in 1 mL?

    5 mg divided by 1 mL is 5 mg per mL. That volume spans 100 U-100 syringe units.

    How does 2 mL change the concentration of this BPC-157 vial?

    5 mg divided by 2 mL is 2.5 mg per mL, half the concentration in the 1 mL column.

    What does the 3 mL column mean for BPC-157?

    5 mg divided by 3 mL is approximately 1.6667 mg per mL. The full 3 mL volume corresponds to 300 U-100 units.

    How many units is 0.5 mg of BPC-157 from this vial in 2 mL?

    0.5 mg divided by 2.5 mg per mL is 0.2 mL, or 20 U-100 units.

    References

    Sources

    Sources checked against the cited documents on 19 November 2026.

    1. Preclinical pharmacokinetics study PMC9794587Identity and research summary checked against this document on 5 October 2026. Abstract and relevant methods/results or product-monograph sections.Retrieved 2026-10-05 · library-reference
    2. FDA, certain bulk drug substances for use in compounding that may present significant safety risksContent current as of 22 April 2026; read on 19 November 2026.Retrieved 2026-11-19 · regulator
    3. Intravenous BPC-157 safety pilot in two adults, 2025 (PubMed 40131143)Abstract: baseline blood work and vital signs were obtained from 2 participants given intravenous BPC-157.Retrieved 2026-11-19 · human-study
    4. Retrospective study of knee injections, 2021 (PubMed 34324435)Abstract: a retrospective study; of the 17 patients, 16 were contacted by phone.Retrieved 2026-11-19 · human-study
    5. PinPoint App Store descriptionFeature wording from the approved application description, not pricing.Retrieved 2026-10-05 · app-description

    Keep your protocol together

    Track the result in the app.

    Set up vials, log doses and sites, and see your next reminder in PinPoint for iOS.

    Download on the App Store
    Syringe readout: 10 units is 0.10 mL on a U-100 insulin syringe
    THE ARITHMETIC / 0.10 mL = 10 UNITS

    Keep exploring

    More tools

    PinPoint app icon

    Your next chapter starts here

    Start Day 1 with
    your numbers in place.

    Your doses, your schedule, your picture. Bring it together in PinPoint.

    Built for iPhone.

    Subscription through the App Store, cancel anytime in your Apple ID settings.