Peptide / Unit conversion

TB-500 reconstitution calculator

Enter your TB-500 vial size, the volume of liquid added and the dose to calculate concentration and syringe units.

Your inputs determine the result. This calculator does not recommend dosages.

Live readout

Set your draw.

Enter your vial strength, diluent, and dose to see the draw.

Mode
Resulting concentration -- mg/mL
Doses per vial --
Syringe

Conversion follows standard mg, mL, and U-100 syringe references.

Performs unit conversions only. Not medical advice. Consult your healthcare provider.

Save preset

After saving, open Presets at the top of the calculator to recall this setup.

Saved presets

No saved presets

Save a conversion from the calculator to recall it later.

    Units chart

    TB-500 units chart (mg to U-100 units)

    TB-500 units chart: mg to U-100 units

    The tables use a 10 mg vial as an example input. No source documents a TB-500 vial size.

    Vial concentration

    Water mL is treated as final solution mL in these columns.

    TB-500: concentration in mg per mL
    Vial contents1 mL water2 mL water3 mL water
    10 mg10 mg/mL10 U-100 units per mg5 mg/mL20 U-100 units per mg3.3333 mg/mL30 U-100 units per mg

    Example vial size (input): 10 mg. No source is cited for this size; it is an arithmetic input, not a sourced fact.

    Amount to units

    Example amounts (arithmetic only, not doses).

    TB-500: amount to U-100 syringe units
    Amount (mg)10 mg + 1 mL10 mg + 2 mL10 mg + 3 mL
    0.2 mg2 units4 units6 units
    0.5 mg5 units10 units15 units
    1 mg10 units20 units30 units
    2 mg20 units40 units60 units
    5 mg50 units100 units150 unitsover one syringe

    Cited amounts

    No human dose has been established. The amount table contains arithmetic examples only.

    How to read this chart

    units = amount ÷ (vial mg ÷ water mL) × 100

    The reconstitution calculator walks through each step, and units to mg converts between mg, mcg, mL and units.

    Reading the 10 mg arithmetic ladder

    PinPoint uses a 10 mg TB-500 vial as an example vial size (input). The table takes five portions of it: 0.2, 0.5, 1, 2, and 5 mg. For the 2 mg row, a 1 mL total volume gives 0.2 mL, while a 3 mL total volume gives 0.6 mL. Those values correspond to 20 and 60 U-100 units. The 5 mg row is the halfway point of the vial, so it reaches 150 units in the 3 mL column and carries the capacity marker there.

    Units, mL and mg/mL

    TB-500 dosage in units and mL

    Searches for TB-500 dosage in units or in mL are conversion questions. Units and mL both measure volume, and what a volume holds depends on how the vial was mixed. The first table gives the concentration of a 10 mg TB-500 example vial (input) at 1, 2 and 3 mL of water; the second shows how many U-100 units each share of the vial takes, and what that share holds. Neither table sets a dose.

    TB-500 10 mg vial: concentration, units per mg and what 10 units hold, by water volume
    Water added Concentration Units per 1 mg 10 units (0.1 mL) holds
    1 mL 10 mg/mL10,000 mcg/mL 10 units0.1 mL 1 mg1,000 mcg
    2 mL 5 mg/mL5,000 mcg/mL 20 units0.2 mL 0.5 mg500 mcg
    3 mL 3.33 mg/mL3,333.33 mcg/mL 30 units0.3 mL 0.3333 mg333.3 mcg
    TB-500 10 mg vial: U-100 units per fraction of the vial, by water volume
    Fraction of the vial Holds Units in 1 mLUnits in 2 mLUnits in 3 mL
    1/20 one twentieth 0.5 mg500 mcg 5 units 0.05 mL 10 units 0.1 mL 15 units 0.15 mL
    1/10 one tenth 1 mg1,000 mcg 10 units 0.1 mL 20 units 0.2 mL 30 units 0.3 mL
    1/5 one fifth 2 mg2,000 mcg 20 units 0.2 mL 40 units 0.4 mL 60 units 0.6 mL
    1/4 one quarter 2.5 mg2,500 mcg 25 units 0.25 mL 50 units 0.5 mL 75 units 0.75 mL
    1/2 one half 5 mg5,000 mcg 50 units 0.5 mL 100 units 1 mL 150 units 1.5 mL over one 100-unit syringe

    TB-500 10 mg reconstitution: worked example

    A 10 mg TB-500 vial mixed with 2 mL of bacteriostatic water holds 5 mg/mL, or 5,000 mcg/mL. On a U-100 syringe 10 units is 0.1 mL, and at this concentration it holds 0.5 mg (500 mcg), one twentieth of the vial. The whole 10 mg is 200 units at 2 mL, more than one 100-unit syringe holds. Mixed with 1 mL instead, the vial is 10 mg/mL and 10 units hold 1 mg; with 3 mL it is 3.33 mg/mL and 10 units hold 0.3333 mg.

    When TB-500 shares a vial with BPC-157, the blend calculator reads both components from one draw, with a printable fraction chart.

    Arithmetic from the example vial size (input) shown, not doses. Water mL is treated as the final volume; a different vial entered in the calculator above gets the same formulas.

    Compound profile

    TB-500 at a glance

    TB-500 is sold as a research peptide.[3] A doping-control laboratory identified the acetylated 17-23 fragment of thymosin beta-4 (Ac-LKKTETQ) in a TB-500 product, and FDA lists TB-500 as thymosin beta-4 fragment (LKKTETQ). It is not the full thymosin beta-4 protein.[3][4]

    Regulatory status
    Not FDA-approved. FDA's 2026 review found no human studies or human exposure data for TB-500 by any route.[5]
    Half-life
    No published half-life value exists for TB-500 in this form.
    Route
    No source describes TB-500 given to people by any route. The app lets you record subcutaneous or intramuscular entries.[5]
    Category
    Peptide
    Vial size
    10 mg, example vial size (input)

    No source gives a TB-500 half-life, and the cited human study used full-length thymosin beta-4, not the fragment. The 10 mg example vial is an arithmetic input; it does not identify the material used in any cited experiment.[5][1]

    Evidence

    What the research says

    The cited human study investigated synthetic thymosin beta-4 delivered intravenously to healthy volunteers. Four cohorts of ten participants received ascending single doses or placebo, followed by a repeated-administration phase. Researchers recorded adverse events and measured pharmacokinetic parameters after single and repeated exposure.[1]

    For the single dose, the abstract describes dose-proportional exposure and a half-life that increased with dose. That finding is more specific than assigning one universal duration to every thymosin-related material. The experiment studied intravenous administration; it did not measure the subcutaneous absorption profile of a retail product labeled TB-500.[1]

    TB-500 is identified as a seven-amino-acid fragment of thymosin beta-4, so it and the full-length protein used in this paper are not interchangeable. FDA did not identify clinical studies in humans assessing the pharmacokinetics of TB-500 by any route. The study supplies related human research context while leaving the identity, formulation, and route differences explicit.[1][5]

    Timing

    Half-life and timing

    No published half-life value exists for TB-500 in this form.

    Calculator details

    About this calculation.

    What is the difference between a TB-500 dose and a vial amount?

    The 10 mg figure is an example vial size for arithmetic, not a listed product or a dose. No human dose has been established. A calculator can convert an independently specified amount into a volume, but it cannot use the example vial to decide the amount.[5]

    Why can a TB-500 dose search lead to misleading vial numbers?

    The 10 mg total is an example vial size (input), not a listed product. The cited pharmacology study concerns full-length thymosin beta-4 given intravenously. A page that presents the vial's contents as though it were a studied administration amount would combine two separate kinds of evidence.[1]

    What concentration is TB-500 at 10 mg in 1 mL?

    10 mg divided by 1 mL is 10 mg per mL. That volume spans 100 U-100 syringe units.

    How does 2 mL change the concentration of this TB-500 vial?

    10 mg divided by 2 mL is 5 mg per mL, half the concentration in the 1 mL column.

    What does the 3 mL column mean for TB-500?

    10 mg divided by 3 mL is approximately 3.3333 mg per mL. The full 3 mL volume corresponds to 300 U-100 units.

    How many units is 1 mg of TB-500 from this vial in 2 mL?

    1 mg divided by 5 mg per mL is 0.2 mL, or 20 U-100 units.

    References

    Sources

    Sources checked against the cited documents on 19 November 2026.

    1. Intravenous synthetic thymosin beta-4 in healthy volunteers, phase 1 trial, 2010 (PubMed 20536472)Abstract read 19 November 2026 (four cohorts of 10 healthy subjects, single intravenous doses of placebo or 42 to 1260 mg, then daily for 14 days). Full text not open. Gives no half-life value.Retrieved 2026-11-19 · human-study
    2. PinPoint App Store descriptionFeature wording from the approved application description, not pricing.Retrieved 2026-10-05 · app-description
    3. The acetylated thymosin beta-4 fragment identified in TB-500, 2012 (PubMed 22962027)Abstract read 19 November 2026: identifies the N-terminal acetylated 17-23 fragment of human thymosin beta-4 (Ac-LKKTETQ) in TB-500.Retrieved 2026-11-19 · primary-reference
    4. FDA, certain bulk drug substances for use in compounding that may present significant safety risksContent current as of 22 April 2026; read on 19 November 2026. Lists "Thymosin beta-4, fragment (LKKTETQ), also known as TB-500".Retrieved 2026-11-19 · regulator
    5. FDA Briefing Document, Pharmacy Compounding Advisory Committee, 23-24 July 2026: TB-500-related bulk drug substancesEvaluation dated 15 May 2026; read 19 November 2026. FDA did not identify clinical studies in humans assessing pharmacokinetics or pharmacodynamics of TB-500 via any route, nor any human exposure data.Retrieved 2026-11-19 · regulator

    From the same library

    Related calculators

    Keep your protocol together

    Track the result in the app.

    Set up vials, log doses and sites, and see your next reminder in PinPoint for iOS.

    Download on the App Store
    Syringe readout: 10 units is 0.10 mL on a U-100 insulin syringe
    THE ARITHMETIC / 0.10 mL = 10 UNITS

    Keep exploring

    More tools

    PinPoint app icon

    Your next chapter starts here

    Start Day 1 with
    your numbers in place.

    Your doses, your schedule, your picture. Bring it together in PinPoint.

    Built for iPhone.

    Subscription through the App Store, cancel anytime in your Apple ID settings.